Trailing-Edge
-
PDP-10 Archives
-
LCG_Integration_Tools_Clearinghouse_T20_v7_30Apr86
-
tools/10backup_v2_3/bms.msg
There are 8 other files named bms.msg in the archive. Click here to see a list.
.title BMS 10BACKUP Messages
.ident 'BMS v2.3'
!
! This module is part of 10BACKUP - a program to read DECsystem-10
! BACKUP tapes in INTERCHANGE mode on a VAX.
!
! This module contains the message definitions for 10BACKUP.
!
! The source modules that make up the 10BACKUP program are:-
!
! 10BACKUP.BAS the main line program.
! BIO.MAR contains tape and file IO routines.
! BUR.MAR is a set of macro utility routines.
! C36.MAR contains 36 bit conversion routines.
! BMS.MSG contains the error message definitions.
! 10BACKUP.RNH Runoff input to build the help library.
!
!
!
.facility 10BACKUP,1/PREFIX=BMS_
!
!
.severity severe
EXCESSERRORS <Giving up because of excess errors - check tape>
!
!
.severity error
UNRECMD <Illegal or misspelled command - please re-enter>
NOTAPE <No tape has been specified - please use the TAPE command>
SIXBITSIZE <Illegal size for SIXBIT record>
SEQERR <Tape block sequence error - blocks lost>
BADDATASIZE <Bad data size in tape block - block ignored>
BADBLOCKTYPE <Illegal block type on tape - block ignored>
BADRECSIZE <Incorrect block size on tape - block ignored>
FILERDWERR <Incorrect file relative data word in block - data lost>
ENDORERR <Last tape operation failed or reached end of tape - use REWIND>
NOOPEN <Error opening output file !AS>/FAO=1
NORPTBLK <No repeat block found after errors detected>
!
!
.severity warning
CHKSUMERR <Check sum error on tape block - block ignored>
NOSSEND <End of Save Set not seen>
NOSSTART <Start of Save Set not seen>
SSNOTFOUND <Specified Save Set not found>
ENDNOSS <End of Save Set found without start>
ENDSSFILE <End of Save Set found while in file>
FILEINFILE <Start of file found while in file>
MIDFILE <File found without start>
EOFNOFILE <End of file found without start>
NONAME <Start of file found without name>
HELPERR <Error accessing help library !AS>/FAO=1
CHECKPAR <CHECKSUM command must specify OFF or ON as parameter>
!
!
.severity information
GOTRPTBLK <Repeat block used to recover from previous error>
IGNRPTBLK <Ignoring unneeded repeat block>
!
!
.END