Enter your search terms Submit search form
	Web pdp-10.trailing-edge.com

FE.DOC -- V2(47)
March 1977






























Copyright (C) 1977
Digital Equipment Corporation, Maynard, Mass.


This software is furnished under a license for use only  on  a  single
computer system and may be copied only with the inclusion of the above
copyright notice.  This software, or any other copies thereof, may not
be provided or otherwise made available to any other person except for
use on such system and to one  who  agrees  to  these  license  terms.
Title  to  and  ownership of the software shall at all times remain in
DEC.

The information in this software is subject to change  without  notice
and  should  not  be  construed  as  a commitment by Digital Equipment
Corporation.

DEC assumes no responsibility  for  the  use  or  reliability  of  its
software on equipment which is not supplied by DEC.

FE2.DOC                                                         Page 2


FE.DOC --V2(47)
March 1977



1.0  SUMMARY

FE is a utility for file transfers between the TOPS-10 file system and
the  FILES-11  file  system.   It handles protocol for the "FE" device
such that FE:  can be addressed as a FILES-11 device, usually  through
-11 PIP.

                           *** CAUTION ***

               The "FE" device is intended for use only
               in  software  development  and  updating
               procedures by knowledgeable people.  Use
               without   proper   caution  may  produce
               unpredictable results.

FE runs under TOPS-10 Release 6.03 and RSX-10F Release V5J or later.

FE depends on the existance of the RSX-20F task T20ACP,  which  should
reside on the -11 file system as "T20ACP.TSK".

Use of FE and file conversion procedures are described in the Guide To
Using the "FE" Device, USEFE.MEM.



2.0  EXTERNAL CHANGES

None.



3.0  KNOWN BUGS AND DEFICIENCIES

As of this document, there are no known bugs or deficiencies.



4.0  INSTALLATION INSTRUCTIONS


4.1  Files Needed to Run FE

FE consists of one file, FE.EXE, and requires the  RSX-20F  task  file
"T20ACP.TSK" to exist on the -11 file system.


4.2  Instructions for Installing FE

Copy FE.EXE to SYS:.

FE2.DOC                                                         Page 3


4.3  Files Needed to Build FE

FE is built from the following files:

     FE.MAC


4.4  Instructions for Building FE

Type the following command:

     SUBMIT FE.CTL/TIME/UNIQ:0/REST


4.5  Special Considerations

None.



5.0  INTERNAL CHANGES

Not applicable.



6.0  SUGGESTIONS

None.



[End of FE2.DOC]